![]() |
Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
![]() |
#1 |
Registered User
Join Date: Apr 2004
Location: Clanton, AL
Posts: 1,253
|
Oops! What did I mess up now?
I finally removed the bed & was cleaning up the frame & such with a wire wheel on a 4.5" grinder. When on the rear end I came across this.
There are apparently about 6 of these little spots that appear to be welded. Unfortunately, I found 2 of them after the wire wheel ate through them. What are they for? How should I close them up? Is it just to keep the elements out & I should use RTV? Or do I need to MIG them back shut? If MIG, do I need to drain the pumpkin first? Thanks, John O>.
__________________
85' CUCV M1009!!! The newest addition! 6.2diesel, Th400, NP208, & only 36k miles! 70' C-10 LWB Fleetside - Looking good these days! ![]() 05' Dodge Neon 88' Winner Escape Sport 1750 - 4.3v6 94' Seadoo SP 84' Honda TRX200, bare nekkid. Just a frame & tires. Always looking for another project or any good deal! ![]() |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|