|
03-01-2007, 10:41 PM
|
#1 |
|
18 Till I Die
Join Date: Mar 2005
Location: Alberta, Canada
Posts: 1,522
|
Metal Glove Box
A fellow board member (Frizzle Fry) PMd me and asked if I could make a metal glove box without the radio side. More like an original replacement. So here we go...
I made a glove box out of 22g galvanized steel using some measurements from my sample dash. I had to see if it would go in in pieces. I didnt want to assemble it and then it didnt fit. Once it went in I put the ends on and then I seen if it would fit thru the hole, and it did. BUT I dont know if there is enough room to get it in on a truck. My dash is on the bench? Heater box might be in the way.
__________________
2011 GMC Acadia 1969 GMC BBC LS7 2007 GMC Crew Duramax 1987 Camaro Iroc 350 Tuned Port Injection 42000Km 1987 Chevrolet Silverado 350 TBI 1987 Chevrolet Silverado 350 TBI(yes 2) Take me drunk, I'm too home... 
Last edited by kelsfine69; 03-01-2007 at 11:05 PM. |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode