65 C-10 Underhood wiring- bulkhead plugs - The 1947 - Present Chevrolet & GMC Truck Message Board Network

HugrOrang71 · 04-08-2007, 10:34 PM

I have 2 plugs coming from the firewall, one is located near the LH inner fender and the other is just just above the RH valve cover. I'm thinking that the LH one feeds the front lighting and the one above the valve cover is the gauge feed, coil power and crank signal to the starter. Correct?

Should there be a wire to a junction block to supply power to the ignition and dash (like on the 67-72 trucks)? Someone had added a large gauge wire from the fuse block through an extra hole in the firewall. I'm not sure if this is what was being used or not?

Any source for a decent wiring diagram?

Thanks,
Jason

04-08-2007, 10:34 PM	#1
HugrOrang71 Bite me, import boy Join Date: Apr 2005 Location: Eagle Point, Oregon Posts: 102	65 C-10 Underhood wiring- bulkhead plugs I have 2 plugs coming from the firewall, one is located near the LH inner fender and the other is just just above the RH valve cover. I'm thinking that the LH one feeds the front lighting and the one above the valve cover is the gauge feed, coil power and crank signal to the starter. Correct? Should there be a wire to a junction block to supply power to the ignition and dash (like on the 67-72 trucks)? Someone had added a large gauge wire from the fuse block through an extra hole in the firewall. I'm not sure if this is what was being used or not? Any source for a decent wiring diagram? Thanks, Jason __________________ Jason '71 C-10 Deluxe-under construction '69 C20, 396,T400-donor truck, '65 C10 project "Facts are meaningless, You can use facts to prove anything that's even remotely true."

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.