1979 3/4 ton axle swap to a 1/2 ton 71'
Ok guys, here is my question: I have a 1979 3/4 ton donor for axles, they are dana 44 front and GM 14 bolt rear w/4:10 gears open diff. I know I will have to change the rear spring perches to fit, but what about the drive lines? The 1979 has a carrier bearing in the rear with a jack shaft, will I need to incorperate this in the swap or can I use a one piece rear drive line? What else may I run into? Both trucks have np 205's.
__________________
1971 cheyenne k10 4 speed np 205 454 BB factory a/c 
Never drink down stream of the herd!
Eric
Last edited by eedgell; 05-06-2007 at 03:39 PM.
|
05-06-2007, 03:37 PM
Threaded Mode