|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
12-03-2002, 11:50 PM
|
#1 |
|
Collector of rusty Items
Join Date: Dec 2001
Location: Sisters,Oregon USA
Posts: 731
|
Front Driveline questions
I am putting the big 1410 u-joints to the rear end, but I am wondering about the front drive line.
I think I need a CV joint on the front driveline and I don't even know if a 1410 is available. I am thinking 1350's I have both 1350 and 1410 drivelines to cut down so the cost there is about the same if a CV is not manditory. It's a 205 case and 4 inch lift with Dana 60 front. Anyone have experience with this? Thanks in advance
__________________
Scrub Sisters, Oregon - Home of the Sisters Rodeo. 70 GMC 1,000,000 + miles 72 K-20 project, 456 Dana60 front, Corp14 rear w/locker, 265R19.5 tires 20-ply. Warn 12k winches both ends, Cross-over steering with raised tie-rod, Powerbox steering, 4500 watt 120-AC power, Air, Hydraulic aux power, 4 inch lift, 5000 lb air-bags both ends. |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode