Spindle Wheel Bearing Help Please - The 1947 - Present Chevrolet & GMC Truck Message Board Network

nartkers · 06-13-2007, 09:21 AM

I was trying to put on my rotors last night and ran into a little problem. The inner wheel bearing fits good on the with the rotor, but there is too much slop on the spindle.
I have a 70c10, but I am using '84 spindle and brake components. I went to autozone this morning, the '84 inner wheel bearing is what I have and it does not work. Basically I need a smaller inner diameter inner wheel bearing with the same outside diamater. Sounds confusing huh?
Any suggestions?
Anyone have a diagram for this setup?

06-13-2007, 09:21 AM	#1
nartkers Registered User Join Date: Jan 2004 Location: Mid-Michigan Posts: 178	Spindle Wheel Bearing Help Please I was trying to put on my rotors last night and ran into a little problem. The inner wheel bearing fits good on the with the rotor, but there is too much slop on the spindle. I have a 70c10, but I am using '84 spindle and brake components. I went to autozone this morning, the '84 inner wheel bearing is what I have and it does not work. Basically I need a smaller inner diameter inner wheel bearing with the same outside diamater. Sounds confusing huh? Any suggestions? Anyone have a diagram for this setup?

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.