|
12-12-2002, 12:24 AM
|
#1 |
|
Registered User
Join Date: Feb 2002
Location: Vacaville, CA
Posts: 2,745
|
Wheel Spacers
 I could get a good deal on a set of these wheels, but... The hole in the back of the wheel is too small to fit over the end of the axle on the rear of the truck. I tried one on, and with about a 3/8 inch spacer and longer studs, they would fit fine. So, I guess I have 3 questions. 1. would it be safe to use a spacer like that? 2. Does anyone know where I could get one made that would work? 3. How much would it cost? ( I am converting to 6 lug disc on the front, and I am going to call tomorrow and get the measurments of the rotor to make sure the front ones would fit.)
__________________
 70 C/10 Light Red 350/TH350, HEI, Duals w/40 series Flows, 91 seat, LED taillights 99 Pontiac S/C GTP, SLP Ram Air hood, GMPP Konis & springs 95 Neon ACR, MP PCM, AFX UDP, 3.0 CAI Last edited by neonlarry; 12-12-2002 at 01:57 AM. |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode