Temp gauge questions - The 1947 - Present Chevrolet & GMC Truck Message Board Network

sub4rvr · 12-30-2002, 01:24 PM

I can't get my temp gauge to work. Is there some way to test the gauge? I've seen in the catalogs that there is an temp gauge resistor. I'm assuming that is mounted to the rear of the gauge. I've used two different sending units. Is it ok to use thread tape on the units, or does it need to be pipe dope. And, is the temp gauge wire to the sending unit green? I can't remember if the gauge worked with the old motor because I only started it a couple of times.

12-30-2002, 01:24 PM	#1
sub4rvr Registered User Join Date: May 2000 Location: Palm Springs, Ca. Posts: 574	Temp gauge questions I can't get my temp gauge to work. Is there some way to test the gauge? I've seen in the catalogs that there is an temp gauge resistor. I'm assuming that is mounted to the rear of the gauge. I've used two different sending units. Is it ok to use thread tape on the units, or does it need to be pipe dope. And, is the temp gauge wire to the sending unit green? I can't remember if the gauge worked with the old motor because I only started it a couple of times. __________________ 72 C10 Suburban 90 S10 57 F100 (2) 67 Mustang (2) 69 Torino GT 00 Mustang GT Conv.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.