Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
09-27-2007, 10:37 PM | #1 |
Licensed to Thrill!
Join Date: Apr 2006
Location: Northwest, GA
Posts: 1,673
|
Building rear tank - what do I need?
OK, so I got my measurements and am having my aluminum tank built.
Basically the same as any other metal tank out there. My only thing is I want to make sure I do everything right. I have my sending unit on the way (universal 5 hole pattern 0-90 ohm). I have my location for the filler figured out. ( http://www.classicheartbeat.com/mark...t_gas_door.htm ) I will be using a vent at the filler (see above link) - do I need any other venting? One question I have - it is apparently against federal regulations to use a bottom mounted pickup (saw it today here: http://www.tanksinc.com/index.cfm/pa...prod/prd83.htm) So, how do I go about doing that? (Using a mechanical pump of course). And, where do I get what I need. What else do I need? Thanks. DLB |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|