a little more dana 44 help please - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Ace in the hole · 10-15-2007, 08:49 PM

I have my front axle apart and have been going thru it with new seals and repacking bearings. Before I go to reassemble it I noticed a missing piece on one side. On the outer axle there is a metal dust cover pressed onto the axle, then there should be a spacer and then the needle bearing and of course the seal. I am missing the spacer on one side. Does anyone have a part # for this spacer?

Also on the side missing the spacer, the metal pressed on dust cover is not flush with where the axle steps down. Shouldn't this be flush with where the axle tappers down to where the nedle bearing rides?

10-15-2007, 08:49 PM	#1
Ace in the hole Registered User Join Date: Apr 2007 Location: Kalamazoo, Michigan, USA Posts: 538	a little more dana 44 help please I have my front axle apart and have been going thru it with new seals and repacking bearings. Before I go to reassemble it I noticed a missing piece on one side. On the outer axle there is a metal dust cover pressed onto the axle, then there should be a spacer and then the needle bearing and of course the seal. I am missing the spacer on one side. Does anyone have a part # for this spacer? Also on the side missing the spacer, the metal pressed on dust cover is not flush with where the axle steps down. Shouldn't this be flush with where the axle tappers down to where the nedle bearing rides? __________________ 1970 K20, 350--- SOLD 05 silverado extended cab short box- duramax Jeep wrangler unlimited

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.