More IFS questions - The 1947 - Present Chevrolet & GMC Truck Message Board Network

ADBob · 10-26-2007, 10:41 PM

Looking to buy a Mustang II IFS for my 1950 Chevy 3100. Read lots of info here on them but still have a couple questions. Right now I am looking at TCI, Heidts, and the Chassis Engineering bolt-in crossmember. Other than a bit easier installation is there any reason to go with the C.E. bolt-in? Between the other two Heidts seems to be more expensive. Is it a better product or just a more expensive product? Suggest away if there is a better product out there for roughly the same $.
Thanks,
Bob

10-26-2007, 10:41 PM	#1
ADBob Registered User Join Date: Feb 2006 Location: Sherwood Park, Alberta, Canada Posts: 20	More IFS questions Looking to buy a Mustang II IFS for my 1950 Chevy 3100. Read lots of info here on them but still have a couple questions. Right now I am looking at TCI, Heidts, and the Chassis Engineering bolt-in crossmember. Other than a bit easier installation is there any reason to go with the C.E. bolt-in? Between the other two Heidts seems to be more expensive. Is it a better product or just a more expensive product? Suggest away if there is a better product out there for roughly the same $. Thanks, Bob

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.