Stance and Lowering Question - The 1947 - Present Chevrolet & GMC Truck Message Board Network

MStokes · 01-07-2003, 03:59 PM

I am in the process of deciding how much I want to lower my 72 C10. I took measurements from the floor to the peak of each fender and came up with the following:

Right Front 32"
Left Front 33"

Right Rear 33 1/2"
Left Rear 34 5/8"

Basically the truck is sitting higher on the left side, both front and back. Would this be due to spring sag and age on the right side? Actually with just a driver sitting in the cab it might be pretty level.

If I went with new springs all around (4" drop in the rear and 2" in the front), would it set pretty level?

01-07-2003, 03:59 PM	#1
MStokes Registered User Join Date: Aug 2002 Location: Meridian, Idaho Posts: 164	Stance and Lowering Question I am in the process of deciding how much I want to lower my 72 C10. I took measurements from the floor to the peak of each fender and came up with the following: Right Front 32" Left Front 33" Right Rear 33 1/2" Left Rear 34 5/8" Basically the truck is sitting higher on the left side, both front and back. Would this be due to spring sag and age on the right side? Actually with just a driver sitting in the cab it might be pretty level. If I went with new springs all around (4" drop in the rear and 2" in the front), would it set pretty level? Attached Images __________________ 1972 C-10 LWB, 400/350, 2WD 1972 C-20 Custom Camper, 350/350, 4WD (Converted)

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.