|
01-09-2003, 07:29 PM
|
#26 |
|
Fabricate till you "puke"
Join Date: Jun 2002
Location: Ill
Posts: 9,402
|
I would think a drop spring would mess with angles more than a block,as the arms set down the pinion will tend to roll nose down,& need a shim. You should see the shaft on my 69.....the back of the rear shaft angle upward to the rear diff! the sum of the 2 angle equal a straightline (trans & diff are phased properly). I have had the u joints in for 3 or 4 yrs, without problem& the shaft spins smooth to 6500 rpms.....thats about topped on 4.10 coggs....crazyL
__________________
69 longhorn,4" chop,3/5 drop, 1/2 ton suspension/disc brakes,1 1/2" body drop,steel tilt clip, 5.3/Edelbrock rpm intake/600 carb, Hooker streetrod shorties,2 1/2" exhaust/ H pipe/50's Flows , 6 spd Richmond trans,12 bolt/ 3.40 gears.... |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode