New member from New Mexico: road_rebel - The 1947 - Present Chevrolet & GMC Truck Message Board Network

road_rebel · 12-31-2007, 05:41 PM

Hello everyone!
I just signed up. Thought I would stop in and see what's going on. I recently acquired a 1970 C10 2wd long-bed stepside with a 292 straight 6 and a 4 speed. The truck is rough. It ran right up to the point where I pulled the exhaust manifold due to some bad cracks. This is the setup with the intake manifold attached to the top of the exhaust manifold. I found a new exhaust manifold from LMC truck but it is on back order. If anyone has any info on where else I could locate a new part?? the help would be greatly appreciated! I also am looking for a bed wood kit for a decent price. Anyway thanks again and have a great new year!!

road_rebel

12-31-2007, 05:41 PM	#1
road_rebel Registered User Join Date: Nov 2007 Location: Las Cruces, NM Posts: 8	New member from New Mexico: road_rebel Hello everyone! I just signed up. Thought I would stop in and see what's going on. I recently acquired a 1970 C10 2wd long-bed stepside with a 292 straight 6 and a 4 speed. The truck is rough. It ran right up to the point where I pulled the exhaust manifold due to some bad cracks. This is the setup with the intake manifold attached to the top of the exhaust manifold. I found a new exhaust manifold from LMC truck but it is on back order. If anyone has any info on where else I could locate a new part?? the help would be greatly appreciated! I also am looking for a bed wood kit for a decent price. Anyway thanks again and have a great new year!! road_rebel

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.