Looking for a wire harness plug.. - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Old Chevy Mech · 01-20-2008, 10:54 PM

I am looking to make a trailer hook up but I do not want to cut into my new wire harness. I want to make a "T" harness using a male & female plug to go between the existing two harnesses. The one on the left is fine, it has enough wire on it. I need the one on the right because the one I have came off the parts truck but was already hacked up by the PO.

So if anyone has the one on the right with about 10-12" of good wire on it I'd be interested in procuring it from you. I dont need the whole rear harness so if the rest is junk but the plug is good that'll suit me just fine.

Thanks!

Frank

01-20-2008, 10:54 PM	#1
Old Chevy Mech Keepin it runnin! Join Date: Oct 2007 Location: Deep River, CT Posts: 1,036	Looking for a wire harness plug.. I am looking to make a trailer hook up but I do not want to cut into my new wire harness. I want to make a "T" harness using a male & female plug to go between the existing two harnesses. The one on the left is fine, it has enough wire on it. I need the one on the right because the one I have came off the parts truck but was already hacked up by the PO. So if anyone has the one on the right with about 10-12" of good wire on it I'd be interested in procuring it from you. I dont need the whole rear harness so if the rest is junk but the plug is good that'll suit me just fine. Thanks! Frank Attached Images __________________ 1970 K-5 4X4 Blazer 1970 K-20 4X4 Long Bed "Liberty Means Responsibility, that is why most men dread it"

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.