|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
01-15-2003, 01:43 PM
|
#1 |
|
Senior Member
 
Join Date: Sep 2001
Location: Seattle, WA, USA
Posts: 5,817
|
Need flaring & tube bending advice...
I may have to fab up a new fuel line from my mechanical fuel pump up to my little 2gv Rochester 2bbl carb. I'm not going to even think about trying to find a pre-bent line.
Anyone have an angle on a good flaring and bending tool set I could buy? I know I'd use it a lot over the years... ...also where do you guys get tubing for fuel, tranny cooling, brakes, etc?
__________________
'69 3/4 ton C20 2wd-350ci/TH400 '69 3/4 ton Custom 20 2wd-350ci/4sp Manual '99 2wd 5.7 Chevy Tahoe Seattle, WA. |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode