![]() |
Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
![]() |
#1 |
Registered User
Join Date: May 2002
Location: Pocatello, Id.
Posts: 8
|
![]()
Hello to all. Have monitored this board for
over a year and have found it to contain a wealth of information, but the time to step up with my own questions has arisen. I recently installed a drop spindle kit (maintained factory springs) and 3" drop springs in rear. After installation I went for a test drive, while cornering I hit a dip in the road and actually caught a bit of my front tire in the fender well. I have 16" rims (6 lug)with a 265x75 tires. I guess I will go to 15" rims (tire size recommendations?) Also it seems like the front and rear tires no longer line up. As if after putting on the front drop spindles with disk brakes the rims and tires set out further then with the drum assemblies. Is it just me or does a disk setup require a different offset on the front rims. Any info or comments would be appreciated! |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|