|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
02-28-2008, 10:31 PM
|
#1 |
|
Senior Member
 
Join Date: May 2006
Location: Philadelphia, Pa. 19454
Posts: 9,773
|
Yukon Jack or other intelligent people-need advise
I'm about to tackle my crossmember clearance problem. YJ, you said you put washers under your big block to get added clearance. Did you put them on top of the motor mount between the engine or in between the motor mount and the engine brace to crossmember.
I am considering making a 1/4" alum. spacer to go between the motor mount and engine brace(tower), just not sure if this is safe. I plan to get a grade 8 bolt 1/4" longer. Any thoughts, help??? Prothane said it should be the same motor mount and the oil pan has the same shape and size on the front half. Just don't know 
__________________
Semper Fi...Uncle Sam, you da man All parts offered to help are free, unless otherwise noted Dont try this stuff in my build thread, unless you have 55 years of mechanical OTJ training SAFETY FIRST AS usual, off topic They say your mind goes second, can't remember the first Jim Last edited by jaros44sr; 02-28-2008 at 10:33 PM. |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode