My new '70 K10 - $ for body work? PICS! - The 1947 - Present Chevrolet & GMC Truck Message Board Network

stllookn · 04-03-2008, 10:36 PM

If you do all the grunt work (disassembly) it will be much cheaper. I did kick panels, partial floor, rockers cab corners and some pillar work for $1000. The guy delivered the truck and patch panels. It had the doors and front clip held on by two bolts each. I finished it with DP90, aligned the doors and front clip when I was done to make sure it was a good fit.

There are some craftsmen around that will work parttime/evenings in your shop too. You just have to look around and check out their work.

04-03-2008, 10:36 PM	#23
stllookn Saving 1 truck at a time! Join Date: Aug 2001 Location: Kent, WA Posts: 6,465	Re: My new '70 K10 - $ for body work? PICS! If you do all the grunt work (disassembly) it will be much cheaper. I did kick panels, partial floor, rockers cab corners and some pillar work for $1000. The guy delivered the truck and patch panels. It had the doors and front clip held on by two bolts each. I finished it with DP90, aligned the doors and front clip when I was done to make sure it was a good fit. There are some craftsmen around that will work parttime/evenings in your shop too. You just have to look around and check out their work. __________________ '68 C20 Longhorn 50th Anniversary 400/TH400 '68 C20 Longhorn 50th Anniversary 468/TH400w/buckets '72 C20 Halfhorn (Longhorn w/o cab and front clip) '69 Flxible Cruiser (look up ugly in the dictionary) Last edited by stllookn; 04-03-2008 at 10:40 PM.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.