WTB section of engine crossmember - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**Yukon Jack** · 05-02-2008, 05:12 PM

I am making a modification to the engine crossmember in my 69 K20 and need a piece from another crossmember to weld into my crossmember. This is a sbc crossmember from a 4wd but I'm guessing the 2wd's crossmember is the same dimension in the area that I need.

Here's a pic of the area that I need. Figure it would be a lot cheaper to ship just the small portion needed, rather than the whole crossmember.

Anyone have a crossmember that they could cut this piece out of for sale?

05-02-2008, 05:12 PM	#1
Yukon Jack Post Whore Join Date: Feb 2000 Location: Rose Hill, KS, USA Posts: 12,689	WTB section of engine crossmember I am making a modification to the engine crossmember in my 69 K20 and need a piece from another crossmember to weld into my crossmember. This is a sbc crossmember from a 4wd but I'm guessing the 2wd's crossmember is the same dimension in the area that I need. Here's a pic of the area that I need. Figure it would be a lot cheaper to ship just the small portion needed, rather than the whole crossmember. Anyone have a crossmember that they could cut this piece out of for sale? __________________ 1970 Blazer with a 400 sbc and 4" lift 1980 Pontiac Trans Am, 455 Oldsmobile 2012 Kawasaki Concours 14

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.