One Piece Drive Shafts - The 1947 - Present Chevrolet & GMC Truck Message Board Network

santana474 · 06-04-2008, 07:27 AM

Hey guys. Am going to be doing a trans swap soon and thought it would be a good time to do a one-piece drive shaft as well. Are there any clearance issues I need to be aware of? Will be putting in a 700r4 and right now am at stock height. Planning on doing a 2.5/3 drop in the future. Will I have to modify the trailing arm cross member? Any other fitment issues that may come up? Just trying to cover all bases here.

Thanks in advance for the help/advise!!

Joe

06-04-2008, 07:27 AM	#1
santana474 Registered User Join Date: Jan 2008 Location: Petal, MS Posts: 60	One Piece Drive Shafts Hey guys. Am going to be doing a trans swap soon and thought it would be a good time to do a one-piece drive shaft as well. Are there any clearance issues I need to be aware of? Will be putting in a 700r4 and right now am at stock height. Planning on doing a 2.5/3 drop in the future. Will I have to modify the trailing arm cross member? Any other fitment issues that may come up? Just trying to cover all bases here. Thanks in advance for the help/advise!! Joe __________________ 72 S/W 350/700R4!!

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.