PARTING: 1969 GMC 3/4 ton - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Frizzle Fry · 06-27-2008, 05:52 PM

I want the front xmember, sway bar, inner fenders, and possibly the lower control arms. Otherwise it all goes.

Cab floor is no good, but I'll cut any sections of the cab out you may want.

The grille and bumper are not straight.

The vent/wing window assemblies actually look pretty good.

It has an Eaton Rear. Unknown if it's a locker (I can check if interested).

The tailgate is not bad. Usable for a work truck and/or could be straightened.

There's too many piece/parts for me to list it all individually. Just let me know what you are intersted in and I'll price it. If you need more pics of anything let me know.

06-27-2008, 05:52 PM	#1
Frizzle Fry Registered User Join Date: Aug 2005 Location: Hillsboro Oregon Posts: 6,449	PARTING: 1969 GMC 3/4 ton I want the front xmember, sway bar, inner fenders, and possibly the lower control arms. Otherwise it all goes. Cab floor is no good, but I'll cut any sections of the cab out you may want. The grille and bumper are not straight. The vent/wing window assemblies actually look pretty good. It has an Eaton Rear. Unknown if it's a locker (I can check if interested). The tailgate is not bad. Usable for a work truck and/or could be straightened. There's too many piece/parts for me to list it all individually. Just let me know what you are intersted in and I'll price it. If you need more pics of anything let me know. Last edited by Frizzle Fry; 07-04-2008 at 11:52 PM.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.