Trying to match sending unit/gage ohms

[SoCal71K20]

I knew I should have payed more attention
during the auto electrical theory part.
Anyways,I know that original temp. sending
unit has resistance listed as 72-88 ohms@
220 degrees.I will use original type gage
with one wire hookup.I cannot use 72-88 ohm
sending unit because of head swap and I want
to keep it off of intake manifold if possible.I can get a newer style sending
unit thats listed as 138-156 ohms @220
degrees.Is there any way to match resistance
to gage?Use of resistor?Hope I didn't word
this too confusing.Thanks.