|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
08-05-2008, 09:55 AM
|
#1 |
|
Registered User
 Join Date: Jan 2007
Location: Poplar Bluff, MO
Posts: 1,502
|
Flaring stainless steel brake lines
I bought stainless brake lines from inline tube and they were pretty good as far as fit but they were too long in the back by 5 inches, so I thought I would by a flaring tool and double flare the line and re-bend it. It seems that I can't get the line to hold in the flaring block I got and I can't get a flare. Is this because I bought a cheap tool? Are the more expensive tools better able to handle this job? Help!
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode