Didn't find the build sheet....yet, but - The 1947 - Present Chevrolet & GMC Truck Message Board Network

ChevLoRay · 09-05-2008, 10:36 PM

I did find a couple of metal tags on the seat springs. They are made just like the seals we used on railcars to seal the doors after we closed them, meaning you have to cut them to get them off. Anyway, they have a date on them, which says "9 10 68" with a seven-digit GM part number stamped in the metal. Wish I had found the build sheet, but the seat has been reupholstered by a previous owner. There's no carpet/pad in it and unless it's behind the gas tank, there ain't no build sheet on my truck. Shucks...

09-05-2008, 10:36 PM	#1
ChevLoRay Old Skool Club Join Date: Jun 2001 Location: Benton, AR "The Heart of Arkansas" Posts: 10,880	Didn't find the build sheet....yet, but I did find a couple of metal tags on the seat springs. They are made just like the seals we used on railcars to seal the doors after we closed them, meaning you have to cut them to get them off. Anyway, they have a date on them, which says "9 10 68" with a seven-digit GM part number stamped in the metal. Wish I had found the build sheet, but the seat has been reupholstered by a previous owner. There's no carpet/pad in it and unless it's behind the gas tank, there ain't no build sheet on my truck. Shucks... __________________ Member Nr. 2770 '96 GMC Sportside; 4.3/SLT - Daily driven....constantly needs washed. '69 C-10 SWB; 350/TH400 - in limbo The older I get, the better I was.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.