Torque bracket mounting - The 1947 - Present Chevrolet & GMC Truck Message Board Network

eric67m · 10-31-2008, 07:08 AM

On my 67 K10 with a NP205 transfer case there is no torque bracket. I assume that this truck originally had a timken (211 or 221?). When the PO swapped in the 205 they did not use the torque bracket and there are no holes in the frame .

To drill the holes in the frame should I ...

Bolt the bracket to the transfer case, bolt the two halfs of the bracket together, mark holes on inside rail of frame, remove tranny/transfercase(replacing anyway), drill holes in frame, reinstall new tranny/transfercase?

OR

Is there a way to measure/drill from the outside of the frame? Does any one have dimensions?

Thanks
Eric

10-31-2008, 07:08 AM	#1
eric67m Registered User Join Date: Apr 2005 Location: Monroe, WA Posts: 298	Torque bracket mounting On my 67 K10 with a NP205 transfer case there is no torque bracket. I assume that this truck originally had a timken (211 or 221?). When the PO swapped in the 205 they did not use the torque bracket and there are no holes in the frame . To drill the holes in the frame should I ... Bolt the bracket to the transfer case, bolt the two halfs of the bracket together, mark holes on inside rail of frame, remove tranny/transfercase(replacing anyway), drill holes in frame, reinstall new tranny/transfercase? OR Is there a way to measure/drill from the outside of the frame? Does any one have dimensions? Thanks Eric __________________ 67 K10, lwb, fleetside, 327, 4spd, 205, cab and 3/4 frame swap, 14 bolt, big window, and a "rustoleum roll job"

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.