|
11-02-2008, 10:08 PM
|
#1 |
|
PISS POOR
Join Date: Dec 2007
Location: visalia, ca
Posts: 98
|
Flat Cam: What Now?
I have been having a really bad rocker tic for several moths now so i finally blew the motor apart to try and figure it out. The exhaust lifter in the number seven cylinder was at least a sixteenth of an inch shorter than all of the other lifters and it had a doming effect going on. So i pulled the cam and sure enough the same lobe was rounded and shot...
So Now I need a New Cam, What do ya'll recommend? 355ci small block, Muncie m21 four speed, flat top forged pistons 10.5:1, 202 double hump heads with screw in studs and guide plates, not sure on the valve springs, edelbrock performer intake, edelbrock 650 cfm carb. I would like a radical sounding solid lifter cam with some pretty respectable power figures, Mileage isn't a problem...  Thanks!  
__________________
Slammed 67 long bed with vette suspention build thread http://67-72chevytrucks.com/vboard/s...d.php?t=291149 Last edited by turbohacker; 11-02-2008 at 10:25 PM. |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode