question for who ever can help - The 1947 - Present Chevrolet & GMC Truck Message Board Network

1sik7t2 · 11-03-2008, 11:15 PM

hey ya all i'm in the middle of dropping in a 6.0 chevy (2005) into my bagged and bodydropped 72' suburban When i lay it out the oil pan hits the ground (no good for draggin sessions) is there some one who makes a shorter pan (would like about two inches or so clearence) that would fit i'm sure someone has run into this problem before PLEASE HELP or do i have to have it sectioned was told a camaro pan was shorter??? will it fit and hold enough????? any directions would be much appreciated thx dave

11-03-2008, 11:15 PM	#1
1sik7t2 dave Join Date: Jul 2007 Location: el cajon Posts: 558	question for who ever can help hey ya all i'm in the middle of dropping in a 6.0 chevy (2005) into my bagged and bodydropped 72' suburban When i lay it out the oil pan hits the ground (no good for draggin sessions) is there some one who makes a shorter pan (would like about two inches or so clearence) that would fit i'm sure someone has run into this problem before PLEASE HELP or do i have to have it sectioned was told a camaro pan was shorter??? will it fit and hold enough????? any directions would be much appreciated thx dave __________________ check out my build "DIRTY BURB"

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.