|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
11-11-2008, 05:20 PM
|
#1 |
|
Registered User
Join Date: Jul 2006
Location: Central PA
Posts: 12,201
|
WTB - PS pump pulley, negative backspacing needed
Need to find a PS pump pulley that will line this pump up with the water pump pulley. Current one is flat but new one will have to have negative backspacing (bell shaped?) I can get exact measurements if needed... any ideas?
Edit: I might also need a 3 groove crank pulley as well... or an add-on crank pulley...
__________________
The Garage: 1968 K-10 SWB - "Project Money Pit" 1996 Z-71 - "huntin rig" 1969 C-10 LWB (SOLD) "Project flip that truck or else" 1993 Passport, F@rd 1-ton (SOLD)"Project Cousin Eddie" My Garage Build "The 1,000 footer" Last edited by msgross; 11-11-2008 at 06:15 PM. |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode