Desperate: Vortec Linkage Pics Needed - The 1947 - Present Chevrolet & GMC Truck Message Board Network

harnalien · 11-18-2008, 11:41 PM

Hello all. I am sending out an S.O.S. for pics of throttle linkage from anyone who has done a vortec head swap. I have an 84 2wd shortbed w/ a 350. I have Edelbrock part# 8032. For the life of me, I can't figure out how to put the configure the bracket. It is either too close to the firewall, or if i flip it, it is too close to the carb. Either way i have it, it does not seem to be in line either. Can anyone post a pic, or tell me what you used for this swap? Thanks in advance.

11-18-2008, 11:41 PM	#1
harnalien TruckincrazY Join Date: May 2004 Location: Haslet, TX Posts: 493	Desperate: Vortec Linkage Pics Needed Hello all. I am sending out an S.O.S. for pics of throttle linkage from anyone who has done a vortec head swap. I have an 84 2wd shortbed w/ a 350. I have Edelbrock part# 8032. For the life of me, I can't figure out how to put the configure the bracket. It is either too close to the firewall, or if i flip it, it is too close to the carb. Either way i have it, it does not seem to be in line either. Can anyone post a pic, or tell me what you used for this swap? Thanks in advance.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.