dana 60 hub locks - The 1947 - Present Chevrolet & GMC Truck Message Board Network

mudmizer · 01-16-2009, 01:40 AM

Anyone know how to get these hubs apart? Is there a C type clip or some sort of retainer holding these together by where my screwdriver is pointing? I can't see anything and I don't want to break the threaded dial. I want to clean them up and gently blast them clean of paint but I want them apart so I can get all the sand out of them.
Second question is why are my old Dana 44 hubs bigger than the new Dana 60? Wish I could use the old heavy dials.
The 60 came from a CUCV.

Thanks
Bob

01-16-2009, 01:40 AM	#1
mudmizer Registered User Join Date: Jan 2007 Location: Bellingham, washington Posts: 260	dana 60 hub locks Anyone know how to get these hubs apart? Is there a C type clip or some sort of retainer holding these together by where my screwdriver is pointing? I can't see anything and I don't want to break the threaded dial. I want to clean them up and gently blast them clean of paint but I want them apart so I can get all the sand out of them. Second question is why are my old Dana 44 hubs bigger than the new Dana 60? Wish I could use the old heavy dials. The 60 came from a CUCV. Thanks Bob Attached Images __________________ 68 4x4, 454, 4 speed, disk brakes both ends, Sold my 69 SS396 Elcamino when young & stupid

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.