|
02-05-2009, 12:31 PM
|
#1 |
|
Registered User
Join Date: Jan 2009
Location: Portland,Oregon
Posts: 6
|
69 C/10 Rear Roll Pan
Has anyone installed one of these and should I have to cut a notch for the recessed license plate inthe back cross plate to make it fit? If I do notch it for the license plate I think it will and then it will leave about 1/8 in gap on each side....Do you just tack weld these to hold in place? And there are also holes accross the top RIVITS,SHEETMETAL SCREWS,OR fill the holes in and WELD it?Need to install asap so I can primer and paint...Thanks for looking and for input....
|
|
|
| Bookmarks |
| Tags |
| 67-72, body, build, custom, roll pan |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode