Intake mounting alignment - The 1947 - Present Chevrolet & GMC Truck Message Board Network

AustinScott · 05-11-2009, 12:46 AM

anyone here use one of these vortec intakes?

The reason I'm asking is because, I can't seem to get the mounting hole to line up, take a look.

FRONT PASSENGER SIDE AFTER GETTING THE DRIVER'S SIDE LINED UP

BACK PASSENGER SIDE AFTER GETTING THE DRIVER'S SIDE LINED UP

EVEN THE 1" MOUNTING BOLTS ARE TO SHORT

I'm just going to return it and get an Edelbrock.
I sure hope its the intake and not my engine.
I am using the Patriot Cast Iron Vortec Heads, I sure hope they are ok,fitment wise.

05-11-2009, 12:46 AM	#1
AustinScott Registered User Join Date: Dec 2007 Location: Southington CT Posts: 548	Intake mounting alignment anyone here use one of these vortec intakes? The reason I'm asking is because, I can't seem to get the mounting hole to line up, take a look. FRONT PASSENGER SIDE AFTER GETTING THE DRIVER'S SIDE LINED UP BACK PASSENGER SIDE AFTER GETTING THE DRIVER'S SIDE LINED UP EVEN THE 1" MOUNTING BOLTS ARE TO SHORT I'm just going to return it and get an Edelbrock. I sure hope its the intake and not my engine. I am using the Patriot Cast Iron Vortec Heads, I sure hope they are ok,fitment wise. __________________ 68-SWB, 327, hooker headers, spintec mufflers, disk brake 3.5/5 drop, buddy buckets, 200-4R, 2200 stall, 3.73 12bolt Eaton Posi, My 68-SWB Photo Build Thread All my Google Albums

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.