|
03-26-2003, 02:39 PM
|
#1 |
|
Registered User
Join Date: Feb 2002
Location: dillsburg pa
Posts: 115
|
help
hello to everyone. i have a small problem. i am trying to start my truck that i just put an hei distributer in and it will not crank. here are the facts. batery is good and i followed the instruction i found on this board about installing the dist. i dont seem to be getting power at all anywhere in the truck. the purple wire going to the dist. is connected to the terminal closet to the engine. what am i missing. i should still have lights even if the wiring to the stater is not right. throw some ideas at me please. thanks in advance.
__________________
67 k-20 w/327 and a 3speed and 4.57 rear with 17 inch split rims and 9 inch wide rubber(is my current project) 73 blazer 6 inch all spring lift 350/350 with crappy 3.08 gears and 35 inch bfg tires. just put out 135 hp to the wheels on the dyno. 54 chevy delray .060 over 250 i-6 which was taken from my first truck(68 gmc). it is next in line for a rebuild |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode