73-87 arms I bought from C10Sim - The 1947 - Present Chevrolet & GMC Truck Message Board Network

m6z · 06-12-2009, 08:00 AM

I purchased a set of control arms from C10Sim. I believed I was receiving a set of controls arms that had been rebuilt and were ready to bolt on. This is what I actually received.

When I received the arms. I was not happy. So I sent a pm to C10Sim.

Quote:

Originally Posted by C10Sim

Quote:

Originally Posted by m6z

Quote:

Originally Posted by C10Sim

Quote:

Originally Posted by m6z

Seriously? I bought the a set of arms with new bushings & ball joints. It would of been appreciate for you to inform me that they were only half done. I was expecting a set of ready to bolt on arms. Not a set that I still had to press out and install a new lower balljoint & finish up assembleing the upper arm.

This is not acceptable,
Doug

Im sorry you feel that way, But the reason they were not pressed in was because my intentions were to powercoat the lower arms and then install them. Sorry for the miscommunication...

If that's was the case. Why didn't you leave both the lowers uninstalled?

The idea came up after I had the bushings installed and this why I stopped there.

Here's a link to the for sale add.

http://www.67-72chevytrucks.com/vboa...d.php?t=345086

I guess my question is. Am I the one in the wrong here? Looking at his original add and picts posted. Would you of thought you were getting a set rebuilt arms that were ready to bolt on?

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.