|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
06-14-2009, 10:38 PM
|
#15 |
|
Account Suspended
Join Date: Apr 2009
Location: Oklahoma City
Posts: 4,709
|
Re: In-truck Head Removal - need advice
If you didn't change the cam, lifters, or piston rings then you don't need a break-in.
As for the electrical stuff, I'm not the guy for that!  When you say you have a hesitation when fuel is applied I'm assuming you mean when you hit the accelerator it stumbles a little? If so, that would most likely be the accelerator pump on your carb. You might also check your vacum advance to make sure it's working good. |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode