I messed up big time - The 1947 - Present Chevrolet & GMC Truck Message Board Network

ol'blu72 · 06-15-2009, 05:53 PM

I am in the process of rebuilding my NP205 transfer case. I was so excited today cause my seal kit came in and I will finally be able to get this beast on the road again. I guess I was in a rush during assembly and forgot to install the shims on the Idler shaft ( I was just about done with assembly too)

The Idler shaft was a pain to get in (a vary tight fit) and upon removal I mushroomed out the threads.

I called around and I cant find one anywhere.

I am seriously pissed! I am going to get out of the garage and drown my sorrows

06-15-2009, 05:53 PM	#1
ol'blu72 Registered User Join Date: Jun 2009 Location: Hampton Roads VA Posts: 333	I messed up big time I am in the process of rebuilding my NP205 transfer case. I was so excited today cause my seal kit came in and I will finally be able to get this beast on the road again. I guess I was in a rush during assembly and forgot to install the shims on the Idler shaft ( I was just about done with assembly too) The Idler shaft was a pain to get in (a vary tight fit) and upon removal I mushroomed out the threads. I called around and I cant find one anywhere. I am seriously pissed! I am going to get out of the garage and drown my sorrows __________________ Brad 72 Blazer CST 350/350/205

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.