The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > 47 - Current classic GM Trucks > The 1967 - 1972 Chevrolet & GMC Pickups Message Board

Web 67-72chevytrucks.com


 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 07-29-2009, 10:06 PM   #1
pritch
Registered User
 
pritch's Avatar
 
Join Date: Mar 2004
Location: Hoytsville, Utah
Posts: 3,365
Front coil spring compressor?

I've recently been putting my front end back together, drop spindles, disc brakes, new coils, the whole thing. I had a dickens of a time compressing my coils. I built this tool:



That is a 3/4" threaded rod and 2 pieces of half inch plate. This is one of my old springs, I didn't take any pictures of doing the new ones. I would like to say it worked well, but all I can say is that it kinda worked. If I took what I learned and built a new one, I would have put some twist in the top steel plate to match the angle of the coil a little better and used left-handed threaded rod so it would get tighter instead of wanting to un-wind it's way down the spring and get looser. As much as I could compress the spring, it still wasn't enough and I had to use a bar clamp between the control arms to get the last little bit so I could get the ball joint nuts to start.
So I did get everything together and I was pretty happy.

Then it was pointed out that I had the bolts upside down in the upper ball joints. The bolts are supposed to be head down, instead of head up.

The shop mechanic at my work had offered to let me use his coil spring compressor tool before hand, so I decided to take him up and this is what he has:



I didn't see a brand name, but I assume this is a good tool. He's the kind of guy that would sooner set fire to a dollar bill as to give it to Harbor Freight.

The problem was that there is no way this would work. It's waaaay to long. I took it apart and made some shorter threaded rods for it:



This was better. This worked for what I was doing. I just needed to hold the springs, just compress enough to relieve the pressure off the ball joint:



I still couldn't compress the spring completely enough, so I still had to finish it with the trusty bar clamp. With this tool this short, there is no way I could have even come close to starting from scratch. No way I could have opened it enough to release the tension on the spring.

But now it's all back together and life is good, but I'm left wondering what is the proper tool to use for this operation?
__________________
'68 Panel
Project Boogie Chillin'
'68 C-10
Ol' Green
pritch is offline   Reply With Quote
 

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 06:41 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com