Need HELP with an engine casting # - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**ScottH** · 09-02-2009, 07:46 PM

Looking at a 68 thats for sale. Buyer claims it has a 350 engine in it, but he is only going by what the PO which he bought it from told him. So I asked him for the casting # so I could verify. He says the casting # on the sbc is 381676. I tried Mortec and a general web search but found no hits on this number.

Can anyone help out identifying this block? The truck is two hours away from me so getting there to see it again is difficult.

Any help is greatly appreciated.

Thanks.

Scott

09-02-2009, 07:46 PM	#1
ScottH Senior Member Join Date: Sep 2002 Location: Hampstead, NC Posts: 8,190	Need HELP with an engine casting # Looking at a 68 thats for sale. Buyer claims it has a 350 engine in it, but he is only going by what the PO which he bought it from told him. So I asked him for the casting # so I could verify. He says the casting # on the sbc is 381676. I tried Mortec and a general web search but found no hits on this number. Can anyone help out identifying this block? The truck is two hours away from me so getting there to see it again is difficult. Any help is greatly appreciated. Thanks. Scott __________________ 1963 C10 swb fleetside 1966 GMC G1000 Handi-bus (future project) 1955 Chevy 2 dr. wagon

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.