going for a run - The 1947 - Present Chevrolet & GMC Truck Message Board Network

purewhitemp5 · 09-27-2009, 04:59 AM

Mon. or Tues. I am running to the JY to remove a seat from a '94 c1500. While I was there I found a couple C-10's '84 up to '87 , 2 '86 K5 blazers and 2 '84 G20 vans with tilt steering. What I would like to know is which of the two (van or pu) would be easier to install into a '68 pu . Wiring is not an issue as I love to do wiring , I might even grab the intermittent wiper set-up while I'm at it.

Also can I grab any other parts off the '84 - '87 pickups ( besides suspension ) that would work with my '68 , like brake booster and mounting bracket , seatbelts , and anything else you can think of.

09-27-2009, 04:59 AM	#1
purewhitemp5 Registered User Join Date: Jun 2009 Location: Bear Delaware Posts: 72	going for a run Mon. or Tues. I am running to the JY to remove a seat from a '94 c1500. While I was there I found a couple C-10's '84 up to '87 , 2 '86 K5 blazers and 2 '84 G20 vans with tilt steering. What I would like to know is which of the two (van or pu) would be easier to install into a '68 pu . Wiring is not an issue as I love to do wiring , I might even grab the intermittent wiper set-up while I'm at it. Also can I grab any other parts off the '84 - '87 pickups ( besides suspension ) that would work with my '68 , like brake booster and mounting bracket , seatbelts , and anything else you can think of. Last edited by purewhitemp5; 09-27-2009 at 05:00 AM.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.