|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
10-20-2009, 10:18 PM
|
#1 |
|
Registered User
Join Date: Oct 2006
Location: In the Indiana Corn
Posts: 449
|
Who has a motor mount (engine side) & a tape measure handy?
I'm trying to fab up some motor mount plates for a project I'm working on, but I don't have a set of motor mounts here. If someone has a mount laying around, would you take a few measurements for me?
This is for the frame side of a typical clamshell mount (the part with the rubber). I need the center-to-center measurement of the top bolts, the center-to-center measurement of the bottom bolts, and the center-to-center measurement from the top bolts to the bottom bolts. Thanks
__________________
1988 R2500 Crew Cab Immediate plans- get it running! Future plans- Rear disc swap & Hydroboost Dually conversion with shackle flip-n-switch 4x4 conversion with 52" springs Maybe some new body panels  Who needs a car when they make crew cab trucks? |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode