Ignition Plate Removal ? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**Ironhorse** · 03-26-2002, 09:26 PM

I know they don't cost much for new replacement and I have one but I generally try to remove parts without breaking them. Does anyone know the trick to removing the ignition/accessory/start/run plate which has a split plastic tab at both ends? Need to remove it to ready the dash for sand, prime and paint. Know how to remove the ignition lock cylinder with the paper clip by inserting with key in and turning to the left then unscrew the ignition faceplate. Just have never had to remove the plastic plate above ignition before. My thanks to all who can give some tips on this.

------------------
1971 Chevy 1/2T 4x4 LWB 350v-8
Wellington, Ks

03-26-2002, 09:26 PM	#1
Ironhorse Senior Member Join Date: Jul 2001 Location: Wellington, Ks Posts: 10,301	Ignition Plate Removal ? I know they don't cost much for new replacement and I have one but I generally try to remove parts without breaking them. Does anyone know the trick to removing the ignition/accessory/start/run plate which has a split plastic tab at both ends? Need to remove it to ready the dash for sand, prime and paint. Know how to remove the ignition lock cylinder with the paper clip by inserting with key in and turning to the left then unscrew the ignition faceplate. Just have never had to remove the plastic plate above ignition before. My thanks to all who can give some tips on this. ------------------ 1971 Chevy 1/2T 4x4 LWB 350v-8 Wellington, Ks __________________ 1971 Chevy 1/2T 4x4 LWB 350 V-8 Was sm465-now 350TH/np205 Tilt, Tach, Towhooks Original Truck AM/FM Wellington, Ks

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.