Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
03-05-2010, 11:55 PM | #1 |
Registered User
Join Date: Dec 2009
Location: DFW, TX
Posts: 764
|
Those with ECE 2" drop in front (Pics added)
How much did you cut off the bump stops?
I finally let mine down off the jack stands after rebuilding the front end. I noticed tonight it is sitting on the bump stops. I put a tape measure to it and it is sitting 2.25" lower than when I started but I think it would go lower if it wasn't for the bump stops. It is bottomed out on both sides. It was rebuilt with all Moog parts and 2" drop springs. I also installed new upper and lower rubber bump stops and KYB shocks. All parts are from ECE. How I measured it. Close up of before measurement. After measurement. Bump stop bottomed out. (Before anyone says it, I know I need to seat the lower ball joint seal. LOL.)
__________________
72 Cheyenne Super 1/2 LWB White/Dark Yellow 07 Avalanche 2LT 74 Sleek Craft Rebel Jet Boat W/Pontiac 400 Last edited by OhOneWS6; 03-06-2010 at 11:06 AM. Reason: Added Pics |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|