'65 leaning a bit - The 1947 - Present Chevrolet & GMC Truck Message Board Network

'70GMCStep · 03-23-2010, 10:49 PM

My '65 is leaning a bit to the driver front side. It was aligned, and drives straight as a pin. I'm sifting through it but have not found the source yet. I have ran it for 50-100 miles (odometer is not working) after putting on new set of control arms and front disc brakes, thinking it would work it's way in, but hasn't yet.
Readjusted the right rear spring today thinking it was out of place. No solution there. When I go around a corner though I get that grabbing feeling from the rear. I mentioned this in a post a few weeks ago, but now wondering if the panhard bar is to blame for drag and the leaning?

Curious as to what you all think.

'70GMCStep

'65 Chevy C-10

'70 GMC Stepside

03-23-2010, 10:49 PM	#1
'70GMCStep Registered User Join Date: Jul 2007 Location: Rogersville, Missouri Posts: 89	'65 leaning a bit My '65 is leaning a bit to the driver front side. It was aligned, and drives straight as a pin. I'm sifting through it but have not found the source yet. I have ran it for 50-100 miles (odometer is not working) after putting on new set of control arms and front disc brakes, thinking it would work it's way in, but hasn't yet. Readjusted the right rear spring today thinking it was out of place. No solution there. When I go around a corner though I get that grabbing feeling from the rear. I mentioned this in a post a few weeks ago, but now wondering if the panhard bar is to blame for drag and the leaning? Curious as to what you all think. '70GMCStep '65 Chevy C-10 '70 GMC Stepside Last edited by '70GMCStep; 03-23-2010 at 10:52 PM.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.