|
03-29-2010, 02:39 PM
|
#1 |
|
Registered User
Join Date: Sep 2008
Location: magalia,ca
Posts: 366
|
HEI Ignition Problem
Hello guys i was hopping i could get a few ideas or maybe an answer to my hei problem.
i have a sb350 with a mallory hei about 8 months ago i replace the cap/rotor/module. about a month later after that, i was driving my truck and it just died (no spark) turns out when i replaced all that stuff i pinched one of the coil wires when i screwed the dust cover on. so i bought a new coil and put it in- everything has been fine sence. today i was pulling out of my driveway and the truck started sputtering and cutting out. i thought it might be a moisture problem so i pulled the cap off everything is dry and the rotor looks good. i noticed whare the carbon brush goes thought the center of the cap (underside) that the plastic was chipped- so figued that was the problem. i got a new cap and put it on i went a round the block and its doing the same thing so i guess that wasn't the problem. im reallllly confused now because yesterday it was runnin fine. so what do you guys think it could be?
__________________
1970 2wd  3/4 ton- 2004 crate 350 thorley tri-y headers-edelbrock performer eps manifold 600cfm performer carb, crane cams energizer cam,lifters, dual 2.5 magnaflows, mallory HEI, powermaster 140 amp altenator, griffen aluminum radiator.(8 MPG )
Last edited by nrb's70gmc; 03-29-2010 at 02:41 PM. |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode