|
04-24-2010, 11:45 PM
|
#1 |
|
Registered User
Join Date: Mar 2010
Location: madison,nc
Posts: 67
|
Truck Help
I need help with my 74 truck. It is a half ton 2 wheel drive with a 350 and three on the tree. The motor has set since 94, and it will turn by hand, but it wont start. At least I dont think it will, I didnt want to try as it may be starved of oil sitting so long.
Ok, so to get to the questions, 1.How would I go about priming the oil up into the motor? 2.Would it help to spray some PB penatrating oil in the cylinders? 3.Ive never used it before, but would spraying starting fluid down the carb.? It has nothing to do with the above questions, but I have already installed the following new parts on it: Coil, distributor cap, points, battery, plugs, oil and filter, fuel filter, all the fuses, belts, and brake pads, rotors, master cylinder, and lines to the front (to get it home. Long story, but it was necessary).
__________________
79 K20,400 SBC, TBI, 4 speed w/ super low, 4.88's. 89 K2500. 350 TBI, mild cam, longtube hooker headers, glasspack true duals, TH700R4 with shift kit, Corp. 14 10.25'' full float, with 4.11:1 gears, standard ifs cranked to 2 inch lift. RS5000 shocks.   96 f350, Powerstroke, ZF6, DRW, 4x4. .Real trucks have 3 peddles. Real drivers float gears!! |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode