![]() |
Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
![]() |
#1 |
Registered User
Join Date: Mar 2009
Location: NW, Colorado
Posts: 285
|
Pulled my head, Need Advice
This is from my jeep. I am sorry, but you all are always so helpful.
The cylinders look pretty smooth. I am concerned that there is way to much carbon built up. Please realize that I had a hell of a time getting the carb and timing set. Also I have 2 distributor gears give out. This again caused timing issues. So the motor has about 3000 miles on it and most were whole I struggled to get it timed out of time. How does the head look? Should I clean it while out? If so how? ![]() How about the pistons? ![]() ![]() Also all the head bolts came out clean, except the very front driver side stud. It was all gummed up with dirty oil/grease. Why would it be messy/gummy? Thanks for the help. I am learning as I go. Thanks a ton. hope to get my new CAM in this week and have it on the road by next weekend |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|