I need some photographic help - The 1947 - Present Chevrolet & GMC Truck Message Board Network

joe231 · 05-14-2010, 11:07 PM

As some of you might know, I'm retro-fitting the entire harness and TBI set-up into my crew cab from a '89 'burb. I am trying to figure out all the routing and some of the wiring. The PO of the 'burb cut the ends off of some of the wiring, including ground lugs and the alternator plug and eyelet. I could use some under hood shots of the wire routing (89-91 Blazer, 'burb or crew) as well as the wires running to the alternator and the power junction block located on the firewall above the brake booster.
thanks in advance guys (and/or gals

)

05-14-2010, 11:07 PM	#1
joe231 Registered User Join Date: Dec 2007 Location: Palmer, Alaska Posts: 13,821	I need some photographic help As some of you might know, I'm retro-fitting the entire harness and TBI set-up into my crew cab from a '89 'burb. I am trying to figure out all the routing and some of the wiring. The PO of the 'burb cut the ends off of some of the wiring, including ground lugs and the alternator plug and eyelet. I could use some under hood shots of the wire routing (89-91 Blazer, 'burb or crew) as well as the wires running to the alternator and the power junction block located on the firewall above the brake booster. thanks in advance guys (and/or gals ) __________________ *CHEVY ONLY*

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.