Tilt column disassembly - The 1947 - Present Chevrolet & GMC Truck Message Board Network

greenhorn male · 05-20-2003, 03:51 PM

I asked this question on another thread but I'm starting a new one to get better visibility. After removing the cover and driving out the 2" pin that I beleive holds in the tilt steps or shoe, what's next? Do I remove the small retainer clip that was next to the pin.
I like to dissasemble my tilt column completely.
With the 2" pin out everything is still tight in place. Could someone get me to where everything is visibly self explanatory, then I'll take it from there.
Thanks,
Luis

05-20-2003, 03:51 PM	#1
greenhorn male Senior Member Join Date: Jan 2003 Location: Bay Area, Northern California Posts: 1,344	Tilt column disassembly I asked this question on another thread but I'm starting a new one to get better visibility. After removing the cover and driving out the 2" pin that I beleive holds in the tilt steps or shoe, what's next? Do I remove the small retainer clip that was next to the pin. I like to dissasemble my tilt column completely. With the 2" pin out everything is still tight in place. Could someone get me to where everything is visibly self explanatory, then I'll take it from there. Thanks, Luis

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.