1 ton and 3/4 ton ball joints the same size? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

lester622 · 06-01-2010, 09:45 PM

Does anybody know if the 1 ton and 3/4 ton balljoints are the same? The reason i ask is because i was looking at ECE's spindles and they list a conversion spindle for a 3/4ton to use 1/2 ton rotors and brakes and so on, but keep the 3/4 ton control arms.

It doesnt say anything about the 1 tons but if i remeber right the ball joints should be the same between 3/4 ton and 1 ton. Does anybody know for sure?

These spindles sure would make it alot less work for a conversion.

06-01-2010, 09:45 PM	#1
lester622 Registered User Join Date: Jan 2008 Location: New Orleans, La. Posts: 229	1 ton and 3/4 ton ball joints the same size? Does anybody know if the 1 ton and 3/4 ton balljoints are the same? The reason i ask is because i was looking at ECE's spindles and they list a conversion spindle for a 3/4ton to use 1/2 ton rotors and brakes and so on, but keep the 3/4 ton control arms. It doesnt say anything about the 1 tons but if i remeber right the ball joints should be the same between 3/4 ton and 1 ton. Does anybody know for sure? These spindles sure would make it alot less work for a conversion.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.